Factory Sample Rigid Rear Fender

2021 New Production rigid rear fender features a cutout for the chain relief as on 1951-57 rigid models and accept stainless fender trim attached by clips.
Fender comes with a 7/8" wide bracket and does not have a tail lamp hole. Before finishing with primer or paint installer must prepare fender by checking alignment of fender tail and bracket. All hinged fenders must be hand fitted at the hinge and pin area. Alignment will have to be adjusted and tweaked to fit your components. Before priming or painting, fit the fender body, braces and mounting points in place. Fender rivets, hinge and brackets will have to be tweaked for final fitment. *NOTE: There are holes in the fender that will need to be filled. Factory sample cover are brand new pre-production parts but have imperfections in the finished surface. Check threaded and bearing holes for excess plating before installation. There are no physical defects, such as cracks or holes, there will be cosmetic imperfections only. Sample parts may show marks from installation test and fitment.