200 XL Rigid Frame 40° Rake

200 XL rigid frame features a 40° rake with a 3" stretch in front legs to accept a 1-1/8" belt with 200 series tire.
Frame has kickstand tab and battery box mount welded in place. Accepts a right side drive transmission and is disc brake type. For use on 1957-1985 XL model. Frame does not have a cross shaft provision for mechanical brakes, available separately as required. Manufacturer's Statement of Origin is supplied for the frame. Includes front and rear motor plate mounts. See photo for installation. These mounts allow 1957-84 ironhead motors to be installed. Addition tabs and brackets may be required as build progresses. Mounts for sissy bar, oil, tank, battery, kickstand and rear fender mounts should be considered in advance before paint and final assembly. Always pre-build first, dissemble then the actual final build! Use spacers which have 3/4" flats, to fit plates with 9/16" axle hole. **NOTE: Check drain plug location for crack case drain, frame cross brace may have to be clearance to allow access to engine drain plug.