Factory Sample Replica Rigid Fender

Factory sample replica rigid rear fender has 1949-1950 style chain relief cutout. Fender is fully assembled and riveted together with hinge.
Before finishing with primer or paint installer must prepare fender by checking alignment of fender tail and bracket, fit the fender body, braces and mounting points in place and must be hand fitted at hinge and pin area. Fender rivets, hinge and brackets and alignment will have to be adjusted and tweaked to fit your components. Fender tail is not drilled or "cut out" for tail lampinstallation. Patience is required for proper installation! We suggest pre-fitting fender prior to painting. *NOTE:Chain panel with ribs is "built in" as one piece with the fender. Factory sample is a brand new pre-production parts but may have imperfections on the finished surface. Check threaded and bearing holes for excess plating before installation. There are no physical defects, such as cracks or holes, there will be cosmetic imperfections only. Sample parts may show marks from installation test and fitment. *NOTE: UPS may consider this part as packaged "oversize" for shipment, as compared to the actual weight, which wil